UNOPLUS Board arduino compatibile PLUS

Esaurito

UNO PLUS è una scheda di sviluppo compatibile con Arduino UNO R3, una soluzione alternativa e migliorata

UNO PLUS è una scheda di sviluppo compatibile con Arduino UNO R3, una soluzione alternativa e migliorata. Fornita con cavetto USB-B USB-micro.
Differenza tra UnoPlus e Arduino Uno REV3
UNO PLUS Vs UNO R3:

UNO PLUS UNO R3 Note
Operating voltage 5V/3.3V 5V Supporta la doppia tensione 3,3V o 5V per gli shield
Reset Lateral Vertical Pulsante laterale per un utilizzo più semplice quando è connesso ad uno shield
Bootloader switch Yes None La scheda può essere configurata per eseguire il programma immediatamente all’accensione tramite lo switch
USB connector Micro USB USB Type B Il connettore micro USB è più comunemente usato e ha un ingombro minore
DC jack Low profile Normal height Shields non sono ostacolati dalle dimensioni del connettore
Power output header Yes None Connettore con uscita a  5V/3.3V e massa
3.3V power output 800mA Max 150mA Max UNO PLUS offre maggior corrente massima in uscita
Oscillator Crystal oscillator Ceramic resonator L’oscillatore a quarzo è adatto per applicazioni in cui è necessario un preciso riferimento di clock
ADC channel 8 6 CFG è utilizzato come ADC6 dalla configurazione e Reserved PIN come ADC7
Connecting with prototype breadboard Supported Not supported Piazzole di saldatura di fianco ai connettori per l’utilizzo con interfaccie e board prototipali
USB driver Compatible with all main systems Doesn’t compatible with WIN7/WIN8 Express Edition Il driver non fallirà mai l’installazione grazie alla FT232 integrata
Firmware fixing Supported Not supported Modifica firmware utilizzando l’FT232 onboard, non è necessario alcun programmatore aggiuntivo
Caratteristiche tecniche
UNO-PLUS on board resource
  1. ATMEGA328P-AU
  2. AMS1117-3.3 : 3.3V voltage regulator
  3. NCP1117ST50T3G : 5V voltage regulator
  4. FT232RL : USB to UART convertor
  5. Arduino interface
    • compatible with standard Arduino interface with two additional analog inputs A6 (config the CFG), A7
    • solder pads provided, supports prototype breadboard
  6. ICSP interface
  7. MICRO USB connector : for uploading program OR serial port debugging
  8. Power output header : 3.3V OR 5V, voltage level configured by the onboard power configuration switch, used as power output OR common-grounding with other boards
  9. FT232 pins : for burning Bootloader into the microcontroller
  10. DC input : 7V ~ 12V
  11. Reset button
  12. Power indicator
  13. Serial port Rx/Tx indicator
  14. User LED
  15. 500mA fast self-recovery fuse
  16. Power configuration : for configuring the operating voltage
  17. Bootloader selection switch
    • turn ON : the board will reset when power-up OR other USB devices were detected connecting to the PC
    • turn OFF : the onboard program runs immediately when power-up, and the board will not reset when other USB devices were detected connecting to the PC
Documentazione e link utili

 

Menu